Bissell Proheat 2x How To Clean Suction Gate

NOTE: There will be no suction to the hose while the Lift-Off Pod is connected to the base

Check for suction at the end of the hose

• Remove Lift-Off pod from base
• With both tanks secure in machine
• Unwind hose, remove tool if attached
• Turn machine on put end of hose in bowl of warm water
• If water in bowl is suctioned up skip down to NO SUCTION TO FLOOR
• If hose did not suction up the water
  • Remove the dirty tank and empty
  • Wipe off red lint screen

• Turn machine on and check for suction at the red lint screen (motor duct)
  • If there is no suction visit a BISSELL Authorized Service Center or Contact Us
• Remove the clean tank
• Remove the suction gate to clean
• The suction gate cover can be removed by unscrewing two Philips head screws and lifting off
• Once off, you may clean the debris from inside

• Make sure the suction gate is properly closed once cleaned
  • If not installed correctly it will cause loss of suction
• Inspect both tanks for damage, replace if damaged
• The red gasket should be attached to the cap on the bottom of the clean tank
  • If missing it should be replaced
  • If found in base of machine, it should be removed and reattached to the bottom of the clean tank

• Fill clean tank with warm water, secure cap tightly and put back in machine
• Return dirty tank to machine
• Turn machine on, checking to see if float is activating prematurely
  • If float is rising to the top when dirty tank is empty, the dirty tank should be replaced
  • If it is not rising to the top of the tank attempt to suction up a bowl of water using the hose
    • If still not suctioning visit a BISSELL Authorized Service Center or Contact Us

Check for suction at the floor

• With Lift-Off pod still off base and set aside
• Confirm the black rectangular gasket is attached to the raised area in the center of the base
  • If not, check the underside of the pod to see if it is stuck there
  • If not, and it is missing it must be replaced

• Remove the 3 screws and remove the top and bottom floor nozzles
• Inspect each for damage, if damaged they should be replaced
• Rinse nozzles and reinsert into machine
• Insert the bottom nozzle by aligning the slots into the corresponding holes & rotate nozzle upward to secure
• The top nozzle notches insert into the bottom nozzle, then rotate upward to secure with screws

• The top nozzle should be flush with the bottom nozzle, no gaps at the seams

• Once reassembled, return Lift-Off pod to base (both clean and dirty tanks are secure)
• To make sure Pod is secured correctly the heated cleaning light should be on once machine is turned on

• Check for suction at the floor by putting a small amount of water down
• Turn machine on, lower handle and attempt to suction up the water
  • If still not suctioning, visit a BISSELL Authorized Service Center or Contact Us
• The Lift-Off pod can be removed and hose used to suction up the water off floor

Bissell Proheat 2x How To Clean Suction Gate

Source: https://support.bissell.com/app/answers/detail/a_id/634/~/my-proheat-2x%E2%AE%2Fdeepclean-lift-off%E2%AE-upright-carpet-cleaner-has-no-suction-%7C

Posted by: jenningsthassences.blogspot.com

Share this post